Buzzing Noise From Furnace: Know the Reasons

Even though new furnaces are quieter than ever, they will still make some noise. If the noise is too loud, you should be aware of unusual heating noises and get professional help like heating services in Whittier, CA. These noises could indicate that your system is malfunctioning and require expert attention. The following are some examples of loud noises that may occur:

• Clicking
• Banging
• Whistling or a high-pitched squeal
• Buzzing or humming
• Rattling

When Your Furnace Starts on for a Heating Cycle, Do You Hear a Buzzing Sound?

While your furnace is running, you will hear a low hum. However, if your furnace emits a loud humming or buzzing sound, it is most likely due to an electrical fault. We’ll discuss what creates the loud buzzing or humming sounds in this blog. The following are the most typical electrical issues that cause it:

• A Loose Transformer Box

The furnace has a transformer that transforms the input voltage to the system’s required voltage. The furnace may start with a buzzing noise if the transformer’s mount becomes loose. A buzzing or loud humming noise on an older furnace indicates that the transformer needs to be changed.

• Bad Capacitor

The capacitor in the furnace stores electricity to enable the motor to start up when the thermostat commands a heating cycle. You may hear a buzzing sound if this component fails. The blower motor circulates warm air through the ducts and into your home. In this case, you will need heat pump repair in Whittier, CA.

• A Blower Motor that is Old or Unlubricated

Your furnace’s blower is driven by a motor, which includes bearings that might wear out over time or due to overheating. Dirt buildup or a faulty capacitor are the most common causes of overheating.

• Loose Ductwork

A furnace’s moving parts might become loose over time or due to improper tightening. If the loud buzzing sound is coming from the duct system rather than the furnace, faulty connections could cause. Because ducts are frequently formed of sheet metal, they can make noises as they expand and contract.

The pressure of air delivered via the HVAC system can cause loose sheet metal portions to vibrate against each other. However, if the noises are excessively loud or frequent, there may be a problem like:

• Dirty air filter
• Closed or obstructed vents
• Undersized or dirty ductwork

What Can You Do?

• Because components need to be replaced, a buzzing furnace will almost certainly need to be repaired by a professional like heat pump repair Whittier CA.
• If the transformer box has just become loose and the transformer has not failed, you may be able to cure the buzzing sound by tightening it up on your own. Tighten the screws and secure the box to the furnace with a screwdriver.
• You might be able to re-secure dangling ducts on your own. Inspect connections for gaps and loose-fitting joints if you have access to the ducts.
• To seal unsecured connections, use mastic sealant or foil tape. Duct tape should not be used for your ducts, despite the name!

We at Lac Heating and Air provide same-day heating services in Whittier, CA, and upfront pricing. Our dependable professionals will always provide you with honest answers and recommendations for any furnace repairs. Contact us to learn more.